MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

Step by step resassembly of the Ihagee original EXA - III
Voir le sujet précédent :: Voir le sujet suivant  


Reply

After some cleaning of all the debris and old lubricants, the reassembly follows the same steps in reverse, the final result look much cleaner than before:

#1 The shutter base looks clean, now the reassembly can start.



#2 Even the spacers look shiny.



#3 Install the left wing where the shutter lever goes.



#4 When placing this part, be careful of pressing the spring end behind





#5 Now place the shutter speed lever elements. There is a small spring wire that might be low of tension, adjust accordingly.





#6 Next place the shutter trigger lever and over it the mirror retainer.



Finally, place the two levers at the bottomside.
With this, we have again a working shutter mechanism.


Jes.


Reply

Wow! It is really clean! I can't wait for final result, how you can make from an orphan camera a new proud guy again!


Reply

We will name this camera 'Oliver' Very Happy

Looks much better in the reassembly than it did in the disassembly stage.


Reply

Laughing


Reply

maddog10 a écrit:
We will name this camera 'Oliver' Very Happy

Looks much better in the reassembly than it did in the disassembly stage.


Good name!. It will keep it Smile.

Jes.