MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

Step by step disassembly of the Ihagee original EXA - I
Voir le sujet précédent :: Voir le sujet suivant  


Reply

Well, thanks to Attila that sent me a Ihagee EXA body I've been able to know more in detail how these nice cameras do work. Although I haven't been able to fix it yet, I know where the problem is, and I've been able to reach that point in the shutter mechanism.

For anyone interested, here are my findings on how to unassemble the EXA:

#1, Remove the viewfinder and the take-up spool. Set the shutter speed in the "B" position.



#2, Remove the right side winding know by loosening the screw in its side





#3, Remove the two screws that hold the top plate



#4, Pull out the top right plate. If you're going to fix some mechanism inside, better place again the winding knob in its place..



#5, Go to the front side and take out the shutter blocker by removing the screw in the middle.



#6, Take out the four screws that support the lens base and take it out



#7, And take out also the three remaining screws that hold the front plate in place (bottom corners and top left corner).



#8, There are two additional screws on top of the front plate that have to be removed as well



#9, Now you can pull out the front plate.



#10, There is still a last screw to remove under the top plate. This one fixes the inside mechanics block to the case.



#11, Finally, remove the two screws inside the camera film holders.






#12, Now, before the internal mechanism can be pulled up it's necessary to remove the film sprocket taking out the two screws on bottom and the top screw that fixes a small gear










#13, So now the internal block should be free and removable from the camera top:



And that's all. It's not needed to disassemble the top left plate (I found it too late Smile ).

Some views, before cleaning and investigating the problem:







Special thanks to Carsten that helped a lot in translating some obscure german words that were making the text ununderstandable to me.

That's all by now.

Jes.


Dernière modification par Jesito le Jeu Août 28, 2008 1:34 pm ; modifié 2 fois au total


Reply

Wow, that's a great project Jes! Your pics make me want to put EXA on my search list Smile Look at the gunge in that camera! Shocked


Reply

Very nice guide !

Its almost the same for an Exakta, with some more complications.


Reply

Nice story. I haven't got one of these but your guide almost makes me want to get one and to have a look inside.