MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

1st Film Problems
Voir le sujet précédent :: Voir le sujet suivant  


Reply

I had a roll of B&W film from one of my Prakticas developed locally. About half of the pics are fine, but the other half show bad over exposure on one side of the photo and there is a distinct line showing.

Unfortunately, I have no scanner so cannot put up samples. I'm thinking that it needs new light seals, or a problem with the shutter.

I have no experience with film so any advice?

Thanks


Reply

The line is most likely a scratch on the film. If it a straight one across the frame it will be a fault of dirt on the camera pressure plate. The xposure problem will again be a camera fault, the shutter is no good or exposure meter has had it. I'm sure it was not user fault!
What do you expect from an old Practica?
Light seals can be cheacked by just looking at them, but a fault there would be fogging not wrong exposure.


Reply

Thanks Rob

The line ran vertically about halfway across the photo and only appeared on the pics that had overexposure on one side.

The over exposure appeared on the left side of the photos and appeared from moderate to severe and then not at all with no obvious pattern. Three different lenses were used.

I'll try and get hold of someone with a scanner to show what the problem was.


Reply

martinsmith99 a écrit:
Thanks Rob

The line ran vertically about halfway across the photo and only appeared on the pics that had overexposure on one side.

The over exposure appeared on the left side of the photos and appeared from moderate to severe and then not at all with no obvious pattern. Three different lenses were used.

I'll try and get hold of someone with a scanner to show what the problem was.


Sounds like a typical case of "shutter drag". Another member was complaining about the same thing. You could most likely have this corrected by a good camera tech.


Reply

Here are some examples. It seemed to happen on the 1st part of the film which was used on a bright day. The 2nd day was overcast and and not a problem. Again, not on every shot.









Reply

It indeed does look like shutter drag. I have thought about light leakage somewhere in the back also, but for that the problem is probably too consistent. Nevertheless: could you check the light seals?


Reply

The seals aren't great condition. If it is a problem with the shutter, it really isn't worth the cost of repair or paying for the processing of another roll of film.


Reply

martinsmith99 a écrit:
The seals aren't great condition. If it is a problem with the shutter, it really isn't worth the cost of repair or paying for the processing of another roll of film.


You can change the foam but Im affraid it wont fix this problem Confused


Reply

I now have more dead cameras than working ones Sad


Reply

martinsmith99 a écrit:
I now have more dead cameras than working ones Sad

You can try the advice I gave Paul with his sticky shutter curtain. Just work it a couple of hundred times and see if it frees up any. What I found invaluable for checking this was Rick Oleson's CRT shutter-speed checking method.http://rick_oleson.tripod.com/index-135.html


Reply

I've worked the camera many times before putting film through it.

Good info on testing, but an expensive method of testing with film.