MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

Pentacon 50mm 1.8 HELP!!!!!
Voir le sujet précédent :: Voir le sujet suivant  


Reply

Can someone help me fix my Pentacon?

The diaphram is stuck wide open, if anyone likes to tinker with lenses I would be more than happy to ship it to you for a repair. no need to worry about screwing it up, it's already screwed!

Drop me a PM ,PLEASE!

Thanks,
Kevin


Reply

I have the same problem...

So if anybody could help in this topic, it would be really fine.
May be the diaphragm needs to be cleaned ?

Thanks.
Olivier


Reply

Does switching the A/M switch and depressing the aperture pin have any effect?

One of my Pentacons had an issue where it would not stop down past f8; turned out to be a worn out plastic part of the A/M switch that just wasn't pressing on the aperture mechanism hard enough. So what I did was opened the back, and took off the spring on the pin mechanism. Now, the A/M switch is completely disfunctional, but I have a fully manual and functional aperture blades that stop all the way down to f16.


Reply

Im sending mine in to a repair shop. Gonna cost me 55.00 USD! The lens isnt even worth that much, but im fixing it just the same. Confused Cool


Reply

spiralcity a écrit:
Im sending mine in to a repair shop. Gonna cost me 55.00 USD! The lens isnt even worth that much, but im fixing it just the same. Confused Cool


55 usd! that is too much!
Try to buy another one from a member and sell yours.


Reply

Definitely buy another one!! They're dime a dozen!!

Cliquez ici pour voir sur Ebay


You will have money left over, and with the broken one, you can use to take it apart and learn about its innards Wink


Reply

It might be oil that got into the diaphragm.
I'm seeing this in a chinon 135mm and in a tokina (its getting slow moving the blades). I found the spring in the chinon was not very strong and it would not move the blades because of the viscosity of the grease between the blades.

Lets hope someone close to you volunteers. If not, buy another one, cuz the shipping will probably be thereabouts...