MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

Gossen Sixtry: clean or not
Voir le sujet précédent :: Voir le sujet suivant  


Reply

What do you think? Does the patina belong to the meter or do I try to clean it. The meter is working and I'm thinkin of using it.



Reply

If you can open it without damage, try a little test clean on an unseen area of the meter scale plate. If it cleans OK or not, this will determine your next course of action.

If you can't open it then you'll have to use it as is.


Reply

On the Sixtino, that plate is anodized aluminium - and anything that can corrode through the anodized layer is capable of eating through the sensor as well...


Reply

Sevo a écrit:
On the Sixtino, that plate is anodized aluminium - and anything that can corrode through the anodized layer is capable of eating through the sensor as well...


Don't really understand?

A) You think that there could still be some substance in the meter that has caused this patina and eats away the sensor (maybe year 2035)?
b) Or that if I try to clean it then I could risk the sensor?

I have opened my Sixtomat umpteen times (and finally replace the stupid band first with a paper band - then with fixed paper scale Mad ). I think the plate comes off with two or four screws with no difficulties.


Reply

[quote="kansalliskala"]
Sevo a écrit:

I think the plate comes off with two or four screws with no difficulties.


I would take the plate off and try to clean it with some water and soft soap, it looks like dust...

Good luck,

Jes.


Reply

Toothpaste was my first choice. Herbal flavour. Smile