MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

Darkroom temperature for printing
Voir le sujet précédent :: Voir le sujet suivant  


Reply

At current, my darkroom temperature is 25,4°C and there is not much hope that it goes down since there was 33°C outside until one hour ago.

Is it critical for developing prints that the chemicals temperature stays at 20°?

Because it would be a trouble to cool them down. My darkroom is tiny and I can not fit an air conditioner there.

Also, while on my Ornano stop and fixer bottles I can read the bath times, there is no indication on the Ilford Multigrade developer. Anybody knows how long the developing time for a RC paper in it?


Reply

25.4C is ok, just develop a little shorter time.

Never really used multigrade but I should think 2 mins max. Is there any tech docs on their site these days?


Reply

Here you go

http://graham.hopto.org/mflenses/ilfordpaperchems.pdf

I'd use the higher dilution or your dev times will be too short.


Reply

Thanks !!

I am excited ! Very Happy