MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

Old Jobo CPA
Voir le sujet précédent :: Voir le sujet suivant  


Reply



Well, I had fibreglassed the tank of the smashed Paterson (which you can see to the left, there), but wasn't really all that happy with it, so had another look at Jobos.
I noticed the older series are going for peanuts, and I got this one for €29+p&p. When it arrived I was slightly surprised at the size of it, being nearly a metre long.




It's a CPA, with a fairly precise control of temperature and a circulating pump, magnetic coupling and two speed reversing drive. A whole leg of quality up from the decidedly home-use Paterson, so even though it's fairly old, I'm quite ok with it.
No chance of fitting the Jobo lift to this one, but I can live without it, I think.
It also occurs to me I can use the smaller Jobo tanks if I arrange another roller assembly and a spray bar above them, discharging warmed water from the pump outlet, which is recessed into the bottom of the trough where the left thermometer is.



Reply

The old series can't fit a lift, and hence none of the lift-adapted huge tanks either. If that is no matter, they are a good choice, their motor control is more reliable (being less overloaded) than that on early series II models.