| Voir le sujet précédent :: Voir le sujet suivant |
| Auteur |
Message |
Kathmandu
 Inscrit le: 09 Déc 2009 Messages: 1479 Localisation: (Kathmandu,Nepal. Currently)Pacific Northwest, USA
Expire: 2012-04-08
|
 Posté: Mer Déc 09, 2009 6:27 pm Sujet du message: Steinheil Culminar 85mm f2.8 dissasembly, Done with this TY |
|
 Posté: Mer Déc 09, 2009 6:27 pm Sujet du message: Steinheil Culminar 85mm f2.8 dissasembly, Done with this TY |
|
|
Kathmandu wrote:
Hi everyone,
I have come to own a Steinheil Culminar 85mmf2.8. I bought this with haze and aperture residue marks thinking I would clean it. I have the lens open from the back and have the rear lens element out. I don't seem to be able to get beyond that- I have used more than reasonable force so far, I did not want to use any more force than necessary.
I am hoping to be able to open the front lens element, that would be my best point of access to clean. I have tried the rubber drain plug to twist the front preset label to no avail.
I have all the screws on the side unscrewed ~and have looked everywhere for information- no luck. My mind hurts from thinking of possible ways to take the front cell off.
Any suggestions or links would be of great value- to me.
Thank you 
Dernière modification par Kathmandu le Dim Déc 13, 2009 5:11 am ; modifié 1 fois au total |
|
| Haut de page |
|
 |
Attila
 Inscrit le: 24 Fév 2007 Messages: 58002
Expire: 2025-11-18
|
 Posté: Mer Déc 09, 2009 7:30 pm Sujet du message: |
|
 Posté: Mer Déc 09, 2009 7:30 pm Sujet du message: |
|
|
Attila wrote:
Welcome!
Little nasty lens I did open one times it takes more than 4 hrs to assembly back. It has plastic aperture holder inside and lot of small screw. Unfortunately I don't know any assembly diagram, hopefully somebody able to help you. |
|
| Haut de page |
|
 |
Kathmandu
 Inscrit le: 09 Déc 2009 Messages: 1479 Localisation: (Kathmandu,Nepal. Currently)Pacific Northwest, USA
Expire: 2012-04-08
|
 Posté: Mer Déc 09, 2009 8:08 pm Sujet du message: |
|
 Posté: Mer Déc 09, 2009 8:08 pm Sujet du message: |
|
|
Kathmandu wrote:
Thank you, luckily I will not have to get to the iris or mess with the aperture blades-they look intact and operate smoothly. I just need to find a way to access through the front to remove the front lens, and clean behind it . Nice forum Attilla. |
|
| Haut de page |
|
 |
Attila
 Inscrit le: 24 Fév 2007 Messages: 58002
Expire: 2025-11-18
|
 Posté: Mer Déc 09, 2009 8:24 pm Sujet du message: |
|
 Posté: Mer Déc 09, 2009 8:24 pm Sujet du message: |
|
|
Attila wrote:
if rubber not work another practice drill two small hole two front ring and you can remove it with spanner wrench. This is last solution if anything else not works. |
|
| Haut de page |
|
 |
Kathmandu
 Inscrit le: 09 Déc 2009 Messages: 1479 Localisation: (Kathmandu,Nepal. Currently)Pacific Northwest, USA
Expire: 2012-04-08
|
 Posté: Mer Déc 09, 2009 10:03 pm Sujet du message: |
|
 Posté: Mer Déc 09, 2009 10:03 pm Sujet du message: |
|
|
Kathmandu wrote:
So the nameplate does come off, is that right? It looked to me like the nameplate and piece on the front barrell is one piece. |
|
| Haut de page |
|
 |
Attila
 Inscrit le: 24 Fév 2007 Messages: 58002
Expire: 2025-11-18
|
 Posté: Mer Déc 09, 2009 10:12 pm Sujet du message: |
|
 Posté: Mer Déc 09, 2009 10:12 pm Sujet du message: |
|
|
Attila wrote:
| Kathmandu a écrit: |
| So the nameplate does come off, is that right? It looked to me like the nameplate and piece on the front barrell is one piece. |
Must be come off perhaps I am wrong and one piece I did opened mine 3 yrs before. |
|
| Haut de page |
|
 |
Kathmandu
 Inscrit le: 09 Déc 2009 Messages: 1479 Localisation: (Kathmandu,Nepal. Currently)Pacific Northwest, USA
Expire: 2012-04-08
|
 Posté: Mer Déc 09, 2009 10:21 pm Sujet du message: |
|
 Posté: Mer Déc 09, 2009 10:21 pm Sujet du message: |
|
|
Kathmandu wrote:
Thanks for jogging your memory back- I dont mean to have you revisit your nightmare again but here is what is looks like~I am sure you knew. |
|
| Haut de page |
|
 |
Kathmandu
 Inscrit le: 09 Déc 2009 Messages: 1479 Localisation: (Kathmandu,Nepal. Currently)Pacific Northwest, USA
Expire: 2012-04-08
|
 Posté: Mer Déc 09, 2009 10:25 pm Sujet du message: |
|
 Posté: Mer Déc 09, 2009 10:25 pm Sujet du message: |
|
|
Kathmandu wrote:
 |
|
| Haut de page |
|
 |
Kathmandu
 Inscrit le: 09 Déc 2009 Messages: 1479 Localisation: (Kathmandu,Nepal. Currently)Pacific Northwest, USA
Expire: 2012-04-08
|
 Posté: Mer Déc 09, 2009 10:30 pm Sujet du message: |
|
 Posté: Mer Déc 09, 2009 10:30 pm Sujet du message: |
|
|
Kathmandu wrote:
I am taking off to go see the birds and the trees for now~I appreciate your time Attila. If that nightmare picture jogs your memory of how you opened it up ~I would be happy to know.
I was at your ebay page- I love that lens spanner tool you have there-looks solid and beautiful . Its sucks that shipping is so much to the US .
Regards |
|
| Haut de page |
|
 |
|
|
|
Vous ne pouvez pas publier de nouveaux sujets dans ce forum Vous ne pouvez pas répondre aux sujets de ce forum Vous ne pouvez pas modifier vos messages dans ce forum Vous ne pouvez pas supprimer vos messages dans ce forum Vous ne pouvez pas voter dans les sondages de ce forum
|