MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

Rotten foam removal
Voir le sujet précédent :: Voir le sujet suivant  


Reply

A friend of mine just off-loaded a box of "junk" on me which included one or two more interesting items. Amongst the stuff was a case in which was a Zenit E with a Helios 44-2 58mm f/2 lens. The only problem is that the foam in the case had gone completely rotten so that everything is now covered in grey gunk. Any suggestions as to the best way to clean this off without damaging the camera, or more importantly the lens?

Also included was a Fuji STX-2 camera with a X-Fujinon 50mm f/1.9 lens and a Sirius MC 80-200mm f/3.9 zoom to go with it, a Lubitel medium format TLR and four different instant film cameras.

The only things I can see myself keeping are the Lubitel and the Helios.

Best wishes, Kris.


Reply

Household alcohol works well, but sometimes it damages plastic so be careful on non-metal parts. Lighter fluid is less efficient but also much less aggressive.

I'd keep the Fuji too if I were you. Smile


Reply

This may sound odd, but you could try using tape.

I use strips of plain clear scotch tape to remove all kinds of marks, adhesives, stickers, fuzz, etc from things. Just hold onto both ends, then stick the middle part over what you want to remove, and pull it back off. Repeat a dozen times or so, and it will pull a little more off each time. Cool

It's especially handy in that it is dry, and that it picks up its own mess. Very Happy


Reply

compressed air will get rid of anything loose and non-sticky, especially tiny particles in hard-to-reach places ...


Reply

Before applying alcohol or lighter fluid, which dissolve foam into a gooey mess, use a blower and soft brush, then wipe with microfiber cloth.


Reply

Hello, there.
You've been greatly advised. An old/spare toothbrush might be useful to help removing the goo.

Cheers, M.


Reply

A toothbrush and either WD40 or lighter fluid are my usual cleaning materials.


Reply

Thanks for all the suggestions. It is cleaning up slowly but I fear it is going to be a long job. Luckily, the glass is nice and clean, it is just the bodywork.

Best wishes, Kris.