MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

My FED2
Voir le sujet précédent :: Voir le sujet suivant  


Reply

S/N 6680745

I'm not entirely sure of the type as there is conflicting evidence on the web.



Pictured here with a Jupiter 8 lens, although it came to me with an Industar 26M but the flare is pretty bad with is so I have swapped to the Jupiter. I also have the Jupiter 3 & 11. The 3 is not yet tested.


Reply

here is a helpful link provided to me by a professional photog friend:

www.commiecameras.com/

hardly politically correct, but a respectful site.

oh, and i just saw your post on rangefinder forum. i am a new member there myself.


Reply

I've had that site bookmarked a while, thanks anyway as it is usefull to others. One other useful site that Poolhall alerted me to is http://www.fotoua.com/1.php?rd=4&st=7

Yes, I'm found in a few forums with this ID. Laughing I'm here more than the others though. Cool


Reply

have you loaded it yet? i am trying to figure if my fumble-fingered self can handle bottom loading in something less than 5 minutes ...


Reply

FED2 isn't a bottom loader. The whole back comes off so it's very easy.


Reply

that's right! hmmmmm ...


Reply

A little late maybe but this site has some very useful production info on the FED range (and others):

http://www.sovietcams.com/index.php?1080963993


Reply

Yes, I've seen that site. It' looks like the D7 version on there, but I'm not sure what the official model is.


Reply

I have saved the infamous Jim's site on hard drive and it says it should be a FED 2(f) V-11, the final one in the classic FED 2 shape, with approximate serial number range 113xxxx through 675xxxx. Here I quote:

"... The main difference between this version and the 'e' that preceeded it is obvious and subtle at the same time. On the obvious side, the body is covered with a nylon material rather than vulcanite, and there are no strap lugs. Otherwise, one would think it entirely the same as a FED-2(e), but such is not the case. Close examination of the body reveals that this version utilizes a different body casting, and while subtle, it blends attributes of the previous FED-2 models (essentially those which conform to the rangefinder width and its attendant top cover) with attributes of the FED-3 which was then simultaneously in production. However, all FED-2(f)s have the 'dual logo' engraving on its face and most typically these cameras were supplied with the sharp f2.8 I-61 'panda' lens."


Reply

Nice one! Looks different from the FED2 I know...


Reply

Good info Seele. Thanks

It gets called so many different names that I've given up caring, but it's good to know about the casing.