MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

FED2 and a Jupiter-12
Voir le sujet précédent :: Voir le sujet suivant  


Reply

I am hoping for some help here!

As some of you may remember I was given a nice FED2 with a Industar-26m lens for Christmas. It worked very nicely and I was happy.

I just won a Jupiter-12 35mm f/2.8 lens on ebay. Annoyingly, I cannot get the lens to mount. The rear lens cap fits both the Industar and the Jupiter quite happily, but the Jupiter just goes round and round in the throat of the camera and the threads do not catch.

Any ideas what may be wrong?

Many thanks, Kris.


Reply

Sometimes hard to screw in , try at both position infinity and shortest too.

Another possible problem is rangefinder adjust arm , if not fully in right position you can't screw in J-12 this did happen with me with my Fed-3a what is basically exactly a FED-2.Either you can try to adjust it or by another FED-2 body.


Reply

set the lens at closest focus. this will keep the rf arm from pushing against the helicoid, and might make it easier to screw in..