MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

I've done!
Voir le sujet précédent :: Voir le sujet suivant  


Reply

Finally,
after some weeks looking for an enlarger with right price (for me), I found it!
I just bought a Durst M609 in perfect condition to print my 6x4,5 shots.
From September (when I came back to my house from my actual commissioned work) I will start printing at last.

Do you have some advice? Some web link to the right workflow?

Luca


Reply

It will be nice if you can find and read the Ansel Adams books, especially 'The print'.
There is a theory there, workflow and lots of examples for printing techniques.
Even there are chemistry recipes if you decide to mix your own chemicals.

In the beginning it looks a lot to read but when you finish with it and try some prints then you realize it is just the foundation and you need to practice more.

good luck with printing Smile


Reply

Look forward seeing the results from the new setup


Reply

Hi, Luca. Let me tell you, there is no right or wrong workflow (apart the obvious, that is). There will be "one" workflow that will eventually work for you and you will find it with the experience, just don't be in a hurry. That said, my advice is to be very consistent with film exposure and development. Just stick with one film and one developer to begin with (I assume we're talking about b&w, but in principle nothing changes). Always make a proof sheet of the entire roll, the rule here is that you have to get viewable frames with no visible edges, the unexposed edges of the film have to be as black as the surroundings, that is. If you cannot achieve this no problem, in most cases you'll be able to make satisfactory prints the same. You pick a frame you want to print and chose then the dimension of the enlargement and set up the enlarger. At this point make a incremental proof at grade 2. Cover with a cardboard all the paper but one strip and expose for 5". Uncover one strip at a time thereafter without moving the paper and expose each strip for 5". Develop and fix. Chose the time relative to the frame that looks best. Expose a fresh sheet with that time. If the contrast is satisfactory you're done, otherwise play with contrast grades. Remember that changing contrast grade the exposure might also need a tweak, your eyes will tell you. This is the process in a nutshell. I do not need to tell you to work under safelight from instant before to take out the paper box to the time the fix is at least at a half. I will not lie to you, you're going to waste lotsa paper in the beginning but after a while you will eventually reach a point when just looking at the initial proof sheet you'll be able to get a working print in the ball park. For a more detailed explanation I advice you to get yourself a good book on the subject. The Print by Adams (already mentioned) is considered by someone a kinda bible, I think it's a very good book along with The Negative and The Camera. If you feel you need a more basic introduction I advice Black & White Photography by Thomas Mc Govern, though I'm not sure if it's available an Italian version. Good light an good luck Smile.
Best, M.