MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

Getting parallels
Voir le sujet précédent :: Voir le sujet suivant  


Reply

It`s a question that I`d like to find the answer.
How to get the camera parallel with the object. I`m talking table/product photography.
The verticals should be easy: a hot shoe level for the camera a level for the object.
How do we determine whether the sides are parallel? Same question applies when shooting the famous brick test.


Reply

With a brick wall you can simply measure it. With a table object that deosn't work as well.


Reply

I think I read it in the test procedure of photozone.de
put a mirror at the center of the target
place your dslr to see yourself at the center
you are parallel Cool


Reply

LucisPictor a écrit:
With a brick wall you can simply measure it. With a table object that deosn't work as well.


It leaves plenty of room for errors.
Say that you test a f/1.4 or f/1.2 lens. The DOF is thin so you have to very accurate with measurement. I`m thinking mm.
Laser beam?

@love that poilu! Very Happy


Reply

Nobody? Anybody?


Reply

Himself a écrit:
Nobody? Anybody?

didn't find any mirror? look in wife bag Wink


Reply

Wait, just wait and I`ll get back to you.
Unexpectedly of course. Stealth mod(e) Twisted Evil


Reply

Hopefully you're not shooting on the kitchen table?

If your tabletop is perfectly square, you could use a draftsman's T-square to line things up.

I can't explain in words, does this sketch make sense to anyone but me?



You'd sight the camera using the line of the square, align it to the live view grid or the focusing dots in the finder.

A macro rail or something would probably help make those fine adjustments accurately.


Reply

Thanks bud.
It makes sense. And I have a T-square too.
The table doesn't have to be square. Any rectangle should do it.