MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

KIRON 1:1 macro 105mm (100mm) repair
Voir le sujet précédent :: Voir le sujet suivant  


Reply

I bought a lens with stuck focusing. I was able to release it but now it's shaky. The reason is probably screw got loosen inside due to much force used to focus. Problem: i cannot remove label ring to open from front side and reach two screws on photo. I'd appreciate good advice.



Reply

Pack barrel in dry ice while warming label ring with hair dryer, shrinking the former while expanding the latter. Hope it's enough so it becomes possible to separate them. Once apart, repair damage to allow future re-assembly/dis-assembly without resort to such extraordinary measures.


Reply

guardian a écrit:
Pack barrel in dry ice while warming label ring with hair dryer, shrinking the former while expanding the latter. Hope it's enough so it becomes possible to separate them. Once apart, repair damage to allow future re-assembly/dis-assembly without resort to such extraordinary measures.


Splendid advice. I'll try. Thanks!


Reply

Didn't work. Next step Smile - see the photo. I know it looks ugly but it was necessary procedure. This was condition to remove focusing ring. And under were the holders i needed to tighten.

Posted is also photo of aperture manipulator, it has prepared different values for other mount probably. M for Minolta...