MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

Lens surface polishing
Voir le sujet précédent :: Voir le sujet suivant  


Reply

Hi, is this Brasso product safe and OK enough to polish mostly surface only or are there any hidden risks (poisons, fumes...) to affect my beloved lenses Very Happy? Or am I gettin' too soft?

I actually find the case in this thread. Carliniphoto, if you are still active - you are god Very Happy!

I'm interested in cleaning metal only, not the cases. Thanks for any word.


Marek


Reply

For polishing the aluminium body of the lens Brasso would do the job, but it is a bit thin and could get inside the lens if you are not careful. A better product would be Autosol -

http://www.autosol.com/ProductDetails.asp?ProductCode=1824

which is a favourite of the custom and classic car collectors. It's a paste and less likely to run inside the lens, and formulated for aluminium.


Reply

Bought your recommended Autosol stuff, got item today, used item today on Primotar and Trioplan, satisfied. (Although it doesn't deal with all those old scares and stains of unknown origin.)

Thanks for advice then.


Reply

The stains will be ingrained in the metal, impossible to shift without removing the surface. The Autosol is good stuff though, I used on motorbike casings.


Reply

Autosol in action Smile (Especially see how Triotar hidden in the back shines on the world)



Five CZ/Meyer lenses in the middle of the photo (+ exa tubes) has been already taken for a cleanup.