MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

Konica Pearl III, HELP needed with rangefinder adjustment
Voir le sujet précédent :: Voir le sujet suivant  


Reply

Just acquired the Pearl III and I have found that the rangefinder is not reporting the correct distance, not even close. I guess I've been lucky because the Pearl is the fifth old rangefinder I have purchased and its the first one noticably off.

Checking around the internet I can find nothing specific to adjusting the rangefinder on Konica Pearl's. So I plunged ahead and removed the top plate and found two screws just behind (closer to the film side) the 45° mirror that is just behind the rangefinder opening (not the viewfinder opening). The screw just behind the mirror adjusted the vertical. The screw behind that adjusted the horizontal. Got it all adjusted at about 8 feet and felt very proud of myself, but then discovered the rangefinder did not converge at infinite. Getting that correct made the close focus off. From what I have read on various forums it seems there are at least two adjustment screws: one for close and one for infinite. But what have I adjusted? Close or infinite? And where is the opposite adjustment screw?


Reply

Welcome ricklb55. Any luck?


Reply

No luck. I tested all my other rangefinder cameras against a known distance and almost all of them were off. Some of them are close enough to fall within the DOF but nevertheless I have decided to use a separate rangefinder device that has tested dead on accurate, AND its easily adjusted, and transfer that distance to my rangefinder cameras.