MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

DIY Macro Rig
Voir le sujet précédent :: Voir le sujet suivant  


Reply

As they saying goes "necessity is the mother of all inventions". I have wanted a self contained macro rig for a long time so I finally set myself to building one. The rig is attached to a piece of 3/4" MDF (Medium Density Fiberboard). The camera/bellows/macro focusing rail is attached to a Z-Flex base and on to a "sled" of MDF that slides between two rails. This sled can be locked in place by a 5/16" star knob. Attached on the other side of the rails is a XYZ macro stage by Wemacro that sits atop a scissors lift lab table. On top of this I place my PVC light tent over which I place up to 3 studio strobes as needed. I have done everything from 1:5 to 5:1 and it works brilliantly.



Reply

Like 1 nice work


Reply

Nicely done! What is the thread of the tapped holes on the top of the x/y slide where you have attached your alligator clip specimen holder (ie. 1/4-20 UNC, etc.).

Thanks,

Paul


Reply

pdccameras a écrit:
Nicely done! What is the thread of the tapped holes on the top of the x/y slide where you have attached your alligator clip specimen holder (ie. 1/4-20 UNC, etc.).

Thanks,

Paul


NC 1/4x20


Reply

Nice job Like 1 small