MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

The Isolette 3 goes West
Voir le sujet précédent :: Voir le sujet suivant  


Reply

Photos with my refurbished Isolette III - Solinar 85mm/4.5 during a road trip trip to Devils tower, covering NE, SD, WY, CO


Agfa APX100, by mistake I made Rodinal 1+10 and noticed it right after i poured the developer... I calculated in my head that somewhere around 3:30 should be enough so I ended up with 4:00 (20 C)


Scotts Bluff NE


The Badlands SD

PS adding more photos from ScottsBluff, thanks @visualopsins



Dernière modification par titrisol70 le Ven Juil 28, 2023 5:08 pm ; modifié 3 fois au total


Reply

titrisol70 a écrit:

Agfa APX100, by mistake I made Rodinal 1+10 and noticed it right after i poured the developer... I calculated in my head that somewhere around 3:30 should be enough so I ended up with 4:00 (20 C)


amazing results!
must try Smile


Reply

Like 1 Like 1 Be sure to look at Flickr -- first two photos (before these) are amazing!


Reply

kansalliskala a écrit:

amazing results!
must try Smile

I did presoak to get rid of the dark green anti halation layer for a few minutes, pour developer, agitated for the 1st 30s and then realised I had screwed up!
Freaked out, did the calculations in my head, agitated once at about 2 min and dumped the dev around 4 min

Negatives are thick, tons of details in the shadows but highlights are dark. From this mistake, somewhere between 3 and 3:30 should be the sweet spot.


visualopsins a écrit:
Like 1 Like 1 Be sure to look at Flickr -- first two photos (before these) are amazing!

Thanks! Added to the post
I'll keep adding more as I scan them, Still have 2 rolls of HP5 to develop (Microphen)


Reply

Another one from Scotts Bluff NE


Reply

Like 1 Like 1


Reply

grumble grumble grumble
I shot some HP5 as well but it fell off the ziplock bag to the bottom of the backpack and seems to have been damaged by the XRay machines!
Devils Tower WY






Fog base is high and that band is present in half the frames


Reply

Like 1 Like 1

I had good results with agfa way back in the 80's, and rodinal 1:50.
I'm pretty sure it was speed rated in the plus-x range, about 100-125, IIRC.
You got some tonal range there, anyways, despite the developer timing.

-D.S.