MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

Action to remove magenta cast
Voir le sujet précédent :: Voir le sujet suivant  


Reply

I have made a Photoshop action that removes magenta cast from expired Fuji slide films. Of course it is no miracle and no end-of-it-all. It is just a starting point. Every photo is different and would ideally require a custom editing. I recommend to duplicate the base layer and to apply the action to the above layer, then use the Opacity slider to control how much of the effect you want applied to your scan.
And of course your scan may -and most probably will- need further fine tuning.
But I thought this could help those not much experienced in Photoshop, to give them a point to start from.

The action can be used with Photoshop CS4 and CS5.

This is the link:
http://www.oriofoto.net/temp/actions/Various_actions.atn

You need to load the action into your photoshop via the "Load action" command in the Actions palette.

P.S. to avoid possible side effect of colour manipulation (such as banding in flat surface areas), make sure your image is in 16 bit mode and in ProPhoto or Adobe RGB colour space before you apply the action. Then you can convert it to 8 bit mode and sRGB colourspace if needed.


Reply

This is very useful, many thanks!