MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

Metal balls
Voir le sujet précédent :: Voir le sujet suivant  


Reply

I keep losing them. You know, the ones usually used for click stops on aperture rings. Where to find replacements other than from busted donor lenses? I found some ballbearing balls on ebay in different sizes, e.g. this: http://www.ebay.de/itm/381344341316?var=650543117490. Is this what I need? Any other advice?


Reply

Micro Tools have various sizes, I think 1.5mm is the common size.

http://www.micro-tools.de/index.php?lang=1&cl=search&searchfieldname=71893b2e3195e0c345023a4aecde4195&71893b2e3195e0c345023a4aecde4195=ball+bearings






.


Reply

Many thanks! Smile I've ordered from micro tools before, I don't know why I didn't think of them myself. I think I'll order a pack or two in each size and see which fits. And they should last a while. Btw, most recently I lost a ball from a Minolta MD lens and it must be tiny. I have another late MD lens (produced by third party supplier I think) that I keep for parts and its ball was far too big, I couldn't use that. So there's not one common size, even in the same brand from the same era.


Reply

Some of the old Canon Breechlock mounts have a load of balls inside them, I think they're 1.5mm as well. So a dead Canon lens can be a good source of balls.


Reply

On the lenses I've dismantled the balls used for the aperture click stops are usually closer to 1mm than 1.5mm. And I've lost a few. Guess I should visit Microtools as well.


Reply

Just a quick follow up. 1.2mm turned out to fit best. 1mm would probably work too, but I thought 1.2mm was better. 1.5mm and bigger were obviously too big.

So if anyone needs to replace aperture ring balls in Minolta MD lenses (in my case it was 100mm/2.5), the correct size is between 1mm and 1.2mm. Smile


Reply

miran a écrit:
Just a quick follow up. 1.2mm turned out to fit best. 1mm would probably work too, but I thought 1.2mm was better. 1.5mm and bigger were obviously too big.

So if anyone needs to replace aperture ring balls in Minolta MD lenses (in my case it was 100mm/2.5), the correct size is between 1mm and 1.2mm. Smile


For my Rokkor, 1.2 mm was actually a bit too stiff. 1.05 mm didn't work either, because the ball would get stuck in the largest slit. In my case, 1.15 mm was perfect Smile


Reply

Get a digital caliper. It is dead useful and absolutely takes the guessing out of issues like that. Just do not, for the love of god, use it as a spanner.