MFlenses - Une nouvelle vie à l’ère numérique
MFLenses 2026

Forum des objectifs à mise au point manuelle

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.

Explorez le monde des objectifs anciens à travers des notes de réparation, des photos d’essai réelles et des archives détaillées.
Pleins feux

Emplacement partenaire mis en avant sur la page d’accueil du forum.

Rolleiflex SL35E
Voir le sujet précédent :: Voir le sujet suivant  


Reply





Body was bought recently from eBay for about $20 total. Described as "parts only."

Arrived in near-mint condition. The only thing wrong was a roll of film inside in need of rewinding -- everything works!

The lens came from a recent flea market sale for about $15 and is worn but works fine and is optically clean.

I am pleasantly surprised with this very nice camera -- the last of the SL-series and completely different from the earlier SLs. Electronic metal blade shutter with speeds of 1/1000 to 16 seconds and 1/125 flash sync. Metered Manual or Aperture Priority Auto exposure modes. Aperture and shutter speed visible in finder. Diagonal split image focusing aid. Accepts conventional cable releases. Accepts 2 motor drive accessories. This camera also has a very quiet shutter -- one of the quietest SLRs I've handled.

The body also came with a sliding viewfinder black-out accessory for tripod use which would probably sell for $20 by itself!

The lens I have for it is older and has the first version of the QBM mount without aperture simulation so must be used in stop-down mode with this camera which normally uses the 2nd version of the mount. Not a big deal but I'm now looking for a deal on a later version lens for it.


Reply

A very good buy congrats.


Reply

dof a écrit:
The only thing wrong was a roll of film inside in need of rewinding -- everything works!


the only issue that I've encountered with the 35sl is advancing the film. The sprocket notches tend to jump out of the film holes. So, as a solution, when loading, I secure the leader with a small piece of tape to the tale-up roll. So far, no problems. When rewinding, it's easy to tell when one gets to that last (the first edge) of film. The tape usually stays connected to the roller and not the film, but I don't imagine a problem if it did stay connected to the film.
BTW, excellent lens!!! Very Happy


Reply

^ Thanks for the tip. Very Happy